Low-voltage electronics · Clear signals
DigitalOsc Measurement Guides
Make sense of bandwidth, sampling and two-channel measurements before choosing a handheld oscilloscope. Explore the FNIRSI 2C53P and practical low-voltage measurement guides.
Practical guides
Correct stored data does not guarantee a steady display if output enable is modulated. Examine the blanking or dimming signal separately from the shift and latch sequence.
Read the guide →Practical guides
A phototransistor optocoupler output depends on its drive, receiving circuit and load. Do not bridge the two sides with common scope grounds to obtain an attractive two-trace co...
Read the guide →Practical guides
A ripple counter does not promise that every output bit switches at the same instant. Decide whether your circuit needs a stable count or a glitch-free decoded transition before...
Read the guide →Practical guides
A high divider stage can take a long time to change. Before concluding that a CD4060 oscillator stopped, check reset and choose an output whose expected period fits your observa...
Read the guide →Practical guides
A hum at the speaker can originate before the amplifier or inside its supply and wiring arrangement. Compare the documented input and output under controlled conditions before a...
Read the guide →Practical guides
A motor driver can ignore a valid-looking input while asleep or in protection. Inspect its documented logic-side conditions before changing the motor command or probing a switch...
Read the guide →Practical guides
An SPI clock burst can exist without a valid DAC update. Check the exact MCP4921 transfer and update conditions, then relate the analogue result to that event.
Read the guide →Practical guides
If a multiplexer selects the wrong input, the ADC may correctly digitise the wrong sensor. Confirm the address and analogue path before adjusting software scaling.
Read the guide →Practical guides
A visible clock is not enough for a CD4017 sequence. Reset and clock-inhibit conditions can prevent counting, while extra edges can make the display appear to skip.
Read the guide →Practical guides
A serial bit stream can faithfully shift the wrong snapshot. Check when the 74HC165 loads its parallel inputs before changing bit order in software.
Read the guide →Practical guides
A 74HC138 decoder combines an address with enable conditions and active-low outputs. An unexpected low line can be the correct selection rather than a fault.
Read the guide →Practical guides
A real-time clock can keep time while its output pin behaves differently from a programme’s expectation. Check whether the exact output is configured for periodic signalling or ...
Read the guide →