DigitalOsc guides
CD4066 Analogue Switch: Control Changes but the Signal Does Not Pass
DigitalOsc editorial team · Updated 20 November 2026
An analogue switch is not a logic buffer. Check its supply, control state, permitted signal range and load before expecting a copy of the input at the output.
Read the exact switch rather than a generic truth table
TI describes the CD4066B as a quad bilateral switch. Establish the exact part, pinout and supply configuration used by the board. Its signal path and control requirements depend on those supply conditions. “Bilateral” does not mean it accepts any voltage or provides galvanic isolation. Confirm the permitted analogue and control ranges from the manufacturer before connecting a source.
Make a simple safe signal path
Use a known low-amplitude signal inside the allowed rails and a load appropriate for the design. Inspect the input source, chosen switch channel and receiving node. With power removed where appropriate, verify continuity of the intended wiring and that another output is not driving the same node. A floating off-state output can retain charge or pick up interference; it need not settle to zero without a defined path.
Observe control and output first
Use two suitable common-reference inputs to capture the channel’s control state and receiving node together. Choose a repetition and timebase that show both on and off intervals. Check actual active polarity against the exact part’s documentation. If necessary, inspect the analogue input in a separate repeatable capture; do not claim that a two-channel record simultaneously measured control, input and output.
Distinguish switching from attenuation
With the switch on, on-resistance and the load can change amplitude. A small signal at the output does not automatically mean the control is wrong. With the switch off, leakage, parasitic capacitance and the surrounding circuit can still affect the output. Compare with the intended operating frequency and load, and avoid interpreting a fast edge through a parasitic path as proof that the channel is fully on.
Use the measurement to choose the next component check
If control never reaches a valid state, investigate its driver and logic levels. If control is valid but the pass signal is wrong, verify the input range, channel connections and load before replacing the switch. Two-input handhelds can help with this relationship; a single-channel unit can check a repeatable node with the simultaneous limit stated. No fixed insertion-loss or leakage performance is claimed for either retail scope or an unidentified module.
Instrument and next step
This is a proposed low-voltage workflow, not a hardware test or a measured fault report. Check the exact instrument, probe and circuit documentation before connecting. If your current equipment already resolves the question, keep using it.
DigitalOsc links to Payverza as the retailer. Current price, availability and delivery are shown there; a product link does not certify accessories, isolation or the suitability of a particular circuit.
Sources and scope
- SWITCH official product or application documentation
- Pico Technology: choosing and using an oscilloscope
Sources checked 20 November 2026. Worked numbers are illustrative; they are not measurements of either retail instrument.