Skip to content

DigitalOsc guides

SPI Peripheral Silent? Check Chip Select and Clock First

DigitalOsc editorial team · Updated 19 November 2026

Use two traces to check whether the intended SPI peripheral was selected when the clock burst arrived.

Measure at the receiver

On a documented common-ground development board, identify the peripheral's clock and select pins. Verify the active select level and allowable I/O voltage in its documentation. Put one input on select and the other on clock at the peripheral. Use a repeated test transaction at a speed your scope and probes can show cleanly.

Compare the boundaries

For a part with active-low select, expect it to assert before the relevant clock burst and remain in its active state until that transfer is done, within the part's setup and hold rules. If select toggles but no clock reaches the part, check routing and clock configuration. If clocks exist while select is inactive, look at the selected software device, pin mapping and transaction boundaries. A burst that ends after select releases can leave only part of the transfer inside the valid window.

Know what you have proved

Two traces answer whether selection and clock timing line up. They do not show a valid command, the correct sampling edge or the reply. After the physical check, consult the data sheet and inspect MOSI/MISO or use a protocol capture. Work with the development board only and keep both grounds on the same known reference.

Useful next steps

References