Skip to content

DigitalOsc guides

Comparator Chatters: Measure Both Trip Points

DigitalOsc editorial team · Updated 19 November 2026

Check rising and falling trip voltages on a slow low-voltage threshold circuit before changing hysteresis.

Make the input move slowly enough to observe

On a documented low-voltage comparator board, check the input range, reference and output type in the exact data sheet. A compatible adjustable input can sweep slowly around the working threshold, staying inside the circuit limits. Look at the input and output together with both grounds tied to the board reference.

Capture the rising and falling trips separately

Imagine the output changes when the input rises through 1.65 V and changes back when it falls through 1.58 V. That setup shows a 70 mV separation. It is evidence of different trip points in that circuit; it is not a product specification. If the output toggles several times at a steady near-threshold input, check noise on the input and reference, the pull-up where applicable, and the intended feedback network.

Use the measured result to decide what to do

Verify the supply and output loading before changing resistor values. If the design requires a particular threshold, compare the measured trip points in both directions with that requirement. A multimeter can confirm steady reference levels; two traces help relate the voltage on the input to the output transition. Stop if the input range or reference is uncertain.

Useful next steps

References