Skip to content

DigitalOsc guides

CD4060 Divider Has No Output: Reset, Divider Stage or Oscillator?

DigitalOsc editorial team · Updated 21 November 2026

A high divider stage can take a long time to change. Before concluding that a CD4060 oscillator stopped, check reset and choose an output whose expected period fits your observation window.

Read the part and chosen divider output

TI describes the CD4060B as a ripple-carry binary counter with oscillator functions. Confirm the exact stage numbering, reset behaviour and external timing arrangement from the data sheet. An output label is not a frequency in hertz. Its rate depends on the actual oscillator and division stage; a guessed timing-component formula is not a substitute for the exact documented circuit.

Choose an accessible buffered output first

Use a suitable safe low-voltage setup and inspect a documented counter output rather than immediately attaching a probe to the sensitive oscillator network. Probe capacitance can change an oscillator’s behaviour. ScopeBench’s crystal-probing guide covers that broader measurement problem; here the initial goal is to establish activity at a buffered divider stage while keeping the source undisturbed.

Allow for the division time

Select a timebase and observation interval consistent with the selected stage. A faster lower-stage output and a slowly changing higher stage can both be normal. In a controlled illustrative divider, repeated division by two produces progressively longer periods; consult the actual stage definition before assigning a ratio. A screen that looks flat for a fraction of the expected period is not evidence that the counter failed.

Use reset and output as a bounded pair

If activity remains absent, compare reset and the chosen output during a documented start condition using appropriate common-reference probes. A held reset can explain missing divided output while leaving the oscillator question unresolved. A two-channel scope preserves that pair; one channel can inspect a steady repeating stage if the source is stable. Save the stage, reset state, timing network and observation length before replacing the IC or disturbing the oscillator.

Choose a handheld for this question

The BSIDE OT3 offers one channel, 10 MHz and up to 48 MSa/s. It may suit a repeating single-node check within its actual limits. Consider the two-input 2C53P only when the question needs a simultaneous comparison; use equipment you already own when it answers the task.

DigitalOsc links to Payverza as the retailer. Confirm the exact probes, accessories, current price and delivery before purchase. This is a proposed low-voltage workflow, not an independent hardware test; a battery-powered case does not establish isolated inputs.

Sources and scope

Examples are illustrative, not measured results. Follow the exact device and probe documentation for pinout, voltage, reference and timing limits. Recheck specifications for the version you actually own.