Skip to content

DigitalOsc guides

I²S Audio Is Silent: Compare Bit Clock and Word Select First

DigitalOsc editorial team · Updated 20 November 2026

For a known low-voltage I²S setup, two scope inputs can show whether bit clock and word select are present together. Valid-looking clocks still do not prove that the audio data or software configuration is correct.

Identify the digital-side pins

On the documented Adafruit MAX98357 I²S amplifier, BCLK, LRC and DIN have different jobs: bit timing, left/right timing and serial data. Confirm the exact board labels and logic-voltage requirements. This guide examines the digital input side only. Do not attach an ordinary common-ground probe across a bridged speaker output; the output topology and required differential equipment are a separate measurement problem.

Capture two clock signals in the same run

With the circuit in a supported safe operating state, use a known common digital reference and appropriate probes. Put one input on BCLK and the other on LRC/word select. Check levels and choose a timebase that includes several word-select periods with enough detail to inspect bit-clock edges. Record the firmware’s intended sample format before interpreting the frequency relationship.

Use a format example, not a fixed rule

A stereo stream with two 32-bit slots per frame can use 64 bit clocks for each frame. At a 48 kHz frame rate that illustrative bit clock is 3.072 MHz. Other slot widths and formats give different relationships, so those numbers are not a universal requirement for every I²S device. Confirm the interface specification and actual configuration; do not reject a working different format because it differs from this example.

If the clocks exist, ask a different question

Clocks alone do not prove nonzero samples, the correct data-pin mapping, channel selection, enable state or a working speaker. Keep a clock capture, then investigate DIN with a suitable setup and the device’s documented timing. A basic handheld scope does not automatically decode I²S. Moving probes for a repeatable check may help, but it cannot turn separate captures into a simultaneous three-signal record.

Choose inputs for the diagnostic scope

Two analogue channels are useful for the clock-pair check; a single input cannot preserve their same-event relationship. For a full digital protocol recording, consider the required inputs, record length and supported decoder separately. The FNIRSI 2C53P is a two-input low-voltage candidate, not a promised I²S decoder. Use equipment you already own if it captures the actual levels and timing you need.

Instrument and next step

This is a proposed low-voltage workflow, not a hardware test or a measured fault report. Check the exact instrument, probe and circuit documentation before connecting. If your current equipment already resolves the question, keep using it.

DigitalOsc links to Payverza as the retailer. Current price, availability and delivery are shown there; a product link does not certify accessories, isolation or the suitability of a particular circuit.

Sources and scope

Sources checked 20 November 2026. Worked numbers are illustrative; they are not measurements of either retail instrument.