DigitalOsc guides
DC Rail Won't Start: Enable, Output and Power-Good
DigitalOsc editorial team · Updated 19 November 2026
Follow the enable, output and status sequence on a documented low-voltage regulator board.
Identify what the board actually exposes
Use the regulator and board documentation to name the input, enable, output and any power-good pin. Some parts do not expose a status output. The TPS62130 is an example that does; check its power-good output and the board's pull-up. Only probe known accessible low-voltage test points with a shared reference.
Start with enable and output
Watch enable on one channel and the requested rail at the load on the other. If enable never asserts, follow the enable path or upstream sequencing. If enable asserts but the output stays low, check input voltage under load and remove the suspect load only as the board instructions permit. A flat trace alone does not identify a bad regulator.
When the rail rises but the board never becomes ready
On the next repeated start, compare output with power-good. An open-drain status pin cannot establish a high level without a suitable pull-up. A stable output with a low or indeterminate status line is a reason to check threshold, pull-up rail, jumper and loading. Log which rail, test points and start conditions produced the evidence before replacing anything.