DigitalOsc guides
BSIDE OT3: Verify a Known Waveform Before Troubleshooting
DigitalOsc editorial team · Updated 19 November 2026
Use a reference signal to separate a probe or setup mistake from an unfamiliar reading on a BSIDE OT3.
Start with a signal you can predict
Use a known low-voltage square-wave source with a common reference, such as a 1 kHz teaching output with a specified swing near 3 V peak to peak. Check the source's level for the actual load. The first goal is to see roughly one cycle per millisecond and the expected swing, not to calibrate the instrument or assess edge fidelity.
Check the probe setting before drawing conclusions
The OT3 brand listing specifies one channel, 10 MHz bandwidth, AC/DC coupling and x1/x10 probe settings. Match the setting to the probe, select DC coupling for level comparisons and start at a scale that leaves headroom. If the period is plausible but the displayed swing is off by about tenfold, check the probe ratio on both sides before blaming the source. If the trace will not settle, put the trigger inside the known voltage swing and check the reference connection.
Use it for one node at a time
After the reference check, take the same probe and settings to a comparable known-low-voltage node. Return to the reference if a surprising result appears. One OT3 input can check a repetitive signal like this. If the question is whether an occasional pulse at one node lines up with another node, use a suitable two-channel instrument or a logic capture instead.
Useful next steps
- View the BSIDE OT3 retailer listing
- Compare single- and dual-channel handhelds
- Check when bandwidth matters