Skip to content

DigitalOsc guides

BSIDE OT3 AC Coupling: Inspect Ripple Without Losing the DC Story

DigitalOsc editorial team · Updated 20 November 2026

BSIDE lists AC and DC input coupling for the OT3. Start in DC to understand the signal’s offset, then use AC only for the question that requires it.

Establish the actual sensor limits first

This workflow concerns a safe low-voltage output whose reference, expected level and source impedance are known. It does not establish an isolated or high-voltage measurement. Read the sensor and probe documentation, connect to a suitable common reference and use an input range that accommodates the complete signal. A large steady offset must remain inside input ratings even if AC coupling later hides it from the display.

Make a DC-coupled baseline

Set the OT3’s physical probe ratio and channel attenuation consistently, select DC coupling and observe the output over the relevant operating change. Record the approximate steady level and the size of the variation. Do not use AUTO to decide what a sensor should do: automatic settings may produce a convenient picture but do not define a valid physical result. The OT3 has one input, so this capture does not simultaneously measure a second reference node.

Switch to AC for a limited question

AC coupling can make a small changing component easier to view by blocking the steady component. After switching, allow the display to settle and choose a suitable scale. The input behaves as a high-pass path, so slow changes and long pulses can droop or appear reduced. The product page’s AC-coupling label does not specify the exact low-frequency response needed for every sensor; verify that separately if it affects the answer.

Do not turn the second picture into a new DC value

If the trace moves towards zero in AC mode, that does not show that the sensor lost its offset. Return to DC to check the actual level. For example, a slowly varying low-voltage position sensor can be better understood in DC mode, while a small faster interference component may be easier to inspect in AC mode. These are proposed observations, not measured OT3 performance.

Choose the next measurement from the result

If the goal is a simultaneous comparison between sensor output and supply, a single-channel OT3 cannot prove their relationship in one transient. Use an appropriate two-input setup if that relationship matters. If one repeatable output is enough, a second instrument may add no value. Save the coupling setting with each screenshot so an apparent change caused by switching modes is not mistaken for a circuit repair.

Instrument and next step

This is a proposed low-voltage workflow, not a hardware test or a measured fault report. Check the exact instrument, probe and circuit documentation before connecting. If your current equipment already resolves the question, keep using it.

DigitalOsc links to Payverza as the retailer. Current price, availability and delivery are shown there; a product link does not certify accessories, isolation or the suitability of a particular circuit.

Sources and scope

Sources checked 20 November 2026. Worked numbers are illustrative; they are not measurements of either retail instrument.