DigitalOsc guides
TCS3200 Colour Values Look Wrong: Check Frequency Scaling and Filter Selection
DigitalOsc editorial team · Updated 21 November 2026
The TCS3200 output is a frequency signal. Changing scaling or filter-selection inputs can change the count without a change in the object being observed.
Confirm the exact breakout and its labels
DFRobot documents the TCS3200 module as converting detected light intensity to an output frequency. Its selection inputs control output scaling and photodiode type; the output-enable connection also matters. Confirm the actual board pin labels and voltage compatibility. A software variable named red is not evidence that the corresponding filter selection reached the sensor.
Make the optical conditions repeatable
Hold the target, sensor distance, angle and illumination steady. Ambient changes or moving the target during a comparison can look like configuration changes. Record whether the board’s illumination is on and whether the sensor sees a uniform area. This is a functional frequency check, not a colour calibration or a guarantee that a paint, screen and printed reference will produce interchangeable values.
Capture configuration and output
For one controlled comparison, put one input on a selection line and the other on OUT, within the documented logic limits and using a compatible common reference. Choose a timebase that shows several output cycles before and after a deliberate setting change. A two-input scope cannot show every selection input at once, so keep the complete programmed state in your notes and verify other lines separately when the experiment is repeatable.
Interpret period and count consistently
A shorter period corresponds to a higher repetition frequency, but a software counter can also be affected by its counting window or missed edges. Compare the actual output period under a fixed selection before changing thresholds in the application. If the intended state never reaches the pin, investigate wiring or firmware. If it does, investigate lighting and sensor response. Do not infer an RGB calibration from the presence of a square wave.
Choose a handheld for this question
Two simultaneous inputs help with the relationship described here; the FNIRSI 2C53P advertises two channels, 50 MHz and up to 250 MSa/s. Check the actual acquisition mode, capture length and probes. A single-channel OT3 cannot capture two nodes in one event.
- Check the exact 2C53P listing
- Compare the current FNIRSI and BSIDE range
- Compare 2C53P versus OT3 for your bench
DigitalOsc links to Payverza as the retailer. Confirm the exact probes, accessories, current price and delivery before purchase. This is a proposed low-voltage workflow, not an independent hardware test; a battery-powered case does not establish isolated inputs.
Sources and scope
- COLOUR manufacturer or technical documentation (source snapshot 2026-11-21)
- PICO manufacturer or technical documentation (source snapshot 2026-11-21)
Examples are illustrative, not measured results. Follow the exact device and probe documentation for pinout, voltage, reference and timing limits. Recheck specifications for the version you actually own.