Skip to content

DigitalOsc guides

Control Knob Jumps: Test the Potentiometer Wiper

DigitalOsc editorial team · Updated 19 November 2026

Check end-to-end motion and separate a bad potentiometer connection from the ADC or software.

Start with a simple repeatable sweep

On a documented low-voltage control board, confirm the potentiometer's outer terminals and wiper. Check that its intended supply and reference are stable. Take readings near both ends, then at a quarter, half and three quarters of travel. Expect a consistent trend for the actual taper; audio or logarithmic pots are not meant to be linear.

Find out where the jump lives

With a meter, a steady reading at a few positions is useful but can miss a short dropout. Watch the wiper while turning slowly through the problem area. On a 3.3 V illustration the wiper rises, dips briefly at the same position, then recovers. Repeat the direction and check the connector so you can distinguish a loose connection from a repeatable track fault.

Follow the same signal to the ADC input

If the wiper remains smooth but the reported value jumps, compare the ADC pin, reference and logged firmware value. Check filtering or a different sampling channel before changing the potentiometer. One scope channel is enough for an initial sweep; a second helps if you need to compare the supply or downstream node at the same instant.

Useful next steps

References