Skip to content

DigitalOsc guides

Audio Distorts: Find Where a Low-Voltage Preamp Clips

DigitalOsc editorial team · Updated 19 November 2026

Compare a clean reference tone with the output of a documented low-voltage preamp stage.

Isolate a small-signal stage

Use a low-voltage preamp board with a documented common reference and a known clean, small sine input. Stay at signal test points. Do not clip a scope ground to either terminal of an unknown speaker output, bridged stage or powered mains amplifier. With the circuit at rest, check bias and supply before applying the test tone.

Compare input and output while turning gain up

If both waves already have flat tops, lower the source or inspect the preceding stage first. If the input stays smooth and the output flattens only when gain is increased, reduce gain and repeat. Compare the top and bottom: a one-sided limit often points to bias or headroom. As a separate check, widen the vertical display range so neither trace is clipped by the scope's acquisition settings.

Report levels with the test conditions

For example, compare a 100 mV peak-to-peak clean input at 1 kHz with the output at two gain settings; include supply, coupling and where it started to flatten. This gives a useful threshold for that setup but is not a distortion measurement. A two-channel instrument shows the reference and output together. A meter alone will not show the shape change.

Useful next steps

References