DigitalOsc guides
74HC138 Selects the Wrong Output: Address, Enable or Active-Low Confusion?
DigitalOsc editorial team · Updated 21 November 2026
A 74HC138 decoder combines an address with enable conditions and active-low outputs. An unexpected low line can be the correct selection rather than a fault.
Establish the truth table for the exact part
TI identifies the SN74HC138 as a three-to-eight line decoder/demultiplexer. Check the package pinout, permitted supply and enable polarities before tracing a board. A line labelled select in a schematic may be active low, so a low output can mean selected. Do not transfer output assumptions from a different decoder or infer enable polarity from the word enable alone.
Choose a small repeatable address experiment
Use a safe low-voltage circuit and one fixed known enable state. Select two documented address combinations and record all three address values and the resulting intended output. A two-channel scope cannot show three address inputs and every output simultaneously. If you vary only one address bit, keep the others explicitly fixed so the capture has a defined meaning.
Compare one address transition and one output
With compatible common-reference probes, observe the changing address bit and the chosen output. Trigger on the deliberate transition and allow time to see stable states before and afterwards. If the expected output never asserts, verify enable conditions and the other address bits before replacing the IC. Incorrect software pin mapping can produce a valid electrical transition on the wrong address pin.
Distinguish selection from transient hazards
Short changes during an address transition can depend on propagation timing and how multiple inputs change. A static correct truth-table result does not guarantee glitch-free dynamic selection for a memory or peripheral. Do not claim a handheld has certified a nanosecond timing budget because a short pulse was not visible. Save the complete state and load conditions, then use appropriate timing specifications and equipment if transient selection matters.
Choose a handheld for this question
Two simultaneous inputs help with the relationship described here; the FNIRSI 2C53P advertises two channels, 50 MHz and up to 250 MSa/s. Check the actual acquisition mode, capture length and probes. A single-channel OT3 cannot capture two nodes in one event.
- Check the exact 2C53P listing
- Compare the current FNIRSI and BSIDE range
- Compare 2C53P versus OT3 for your bench
DigitalOsc links to Payverza as the retailer. Confirm the exact probes, accessories, current price and delivery before purchase. This is a proposed low-voltage workflow, not an independent hardware test; a battery-powered case does not establish isolated inputs.
Sources and scope
- HC138 manufacturer or technical documentation (source snapshot 2026-11-21)
- PICO manufacturer or technical documentation (source snapshot 2026-11-21)
Examples are illustrative, not measured results. Follow the exact device and probe documentation for pinout, voltage, reference and timing limits. Recheck specifications for the version you actually own.